• Support
  • Problem with stereo mono and autoplay

Borisa month ago
I have two problems also

on my Iphone i have lost pan channel possibility but I did not switch mono switch in settings do I need to reinstall stagetraxx 3 i turn off phone and switch on again but problem is there also I do not have that kind of problem with my Ipad on both devices I install new IOS
problem is on playlist I switch on autoplay also on individual songs but player wont play song on list automatic playes stops how I can set on playlist player to play all set list without stop or needed to press next song

I just tried with iPhone and iPad and the panning option works on both if you don't have the Mono setting enabled. So maybe the problem is with your connection of the iPhone to the PA system.

Regarding autoplay: Make sure that you have Advanced Queue mode disabled. When this mode is enabled, Autoplay settings are only activated when you turn them on in the Queue or load a whole playlist into the queue.

    22 days later

    peter
    Is there a way to output only in one Chanel ; what I mean is : using an audio interface and choosing an output 1/2 or 3/4 it sends the signal in stereo! when activating the mono option nothing actually changes cause the signal goes in both Chanels 1/2 or 3/4 and not only to 1 or 2 or 3 or 4 wich dosent make sense! and the only way to actually output to only one mono Chanel is paning each song to the left or right wich is insane as you can imagine its not that easy.
    So is there a way to output only to one Chanel like when panning a song; because its impossible to do it for every song independently!!
    Thank you in advance

    What the mono option does is to sum up left and right and output this mono sum on both sides of the stereo output so that you can connect your iPad with either side of the output to your PA.

    What you describe with panning will not lead to a true mono signal because one side of the signal is lost if you do it that way.

      2 years later

      peter Can you please remind me how to do this? I want to use one mono channel on the mixer from the iPad headphones socket. I searched the manual and the forum without any result. Thanks.

      Select Headphone Left or Headphone Right in Settings > Audio Routing as the output for Stereo Song Output.