Midi to synths

Boris

I have network of midi devices Roland GR55 synt pedal, Helix 6, ZoomB3, TC Helicon live extreme 3 and Qu16c Mixer, Korg pa4x synt, so I use IconnectivityMIDI4+ for master of midi network some devices are connected by midi 5 pin some with USB B all devices are on midi in Ipad is master and StageT3 all devices changes patchs on command in lyrics of StageT3 [midi@00:00.60: CC32.002@1, PC.015@1, CC69.000@1] all devices are on midi channel 1 just for testbut I have problem with mixer Allen heat Qu16c with hex midi chart I want to change scene on him

derums13

Boris Did you ever figure out how to control your gr55 guitar synth with midi mapping and stage traxx3? If so what was the systax to select the User bank or any bank and then the Program change for specific patch?

peter

The problem is most likely your PC command. You use the PC format that also sends bank select messages by adding the dot to the command. So in fact when you write cc0.85@1,cc32.0@1,PC5.0@1 Stage Traxx will send cc0.85@1,cc32.0@1 like you specified, but then it will send another bank select from the PC command: cc0.0@, cc32.0@1 ,PC5@1

So to only send a PC after the two manual bank select commands, write: cc0.85@1,cc32.0@1,PC5@1

See here for details: https://stagetraxx.com/user-guide/midi/#bank-select-and-program-changes

CrimsonMedici

Thanks Peter for the reply. I tried that and sadly it still doesn’t work. This is for a Roland system 8 synth …

peter

Try 84 or 86 for MSB. Who knows if numbering on Roland devices starts with 0 or 1.

CrimsonMedici

Thanks Peter so - on ableton the midi is set for bank 86 set 2 Pgm 5 - this works fine via a USB cable to the system 8
I have the following in st3
[midi@play: cc00.86@1,cc32.2@1,PC5@1]

If I set st3 to listen and select the sound it records the following ; [midi: PC5.0@1]

Neither works when I start the song. I can see the data transferring to the system 8.

The system 8 is set to RX midi channel 1. - I have checked all ports showing on the midi section in playback on st3

CrimsonMedici

That’s what’s being sent on midi.

CrimsonMedici

CrimsonMedici just to add - that’s sending 2 midi messages - 1. To the system 8 ch1 and Jupiter 80 synth on 16. Thr j80 once it receives the midi tells me that midi offline 🙁

Both work fine with Ableton

peter

Sorry, no idea. Looking at the midi monitor all seems to be ok on the ST3 side.

CrimsonMedici

Thanks Peter something is off so I’ll check the synths again

CrimsonMedici

Hi all - thought Id give an update. After replacing the cables (didnt change anything) i finally bit the bullet and factory reset both my synths. Boom everything works! So there you have it...

Thanks all

Nick