Midi Pc and CC commands from Stagetraxx 3 to hx stomp issues

nstn5266

I have been sending PC changes to my stomp when loading a song in stagetraxx 3. loads a preset for song. Got this working fine, Than added a second command CC to change to a snapshot. Works sometimes and other times locks up my stomp. Can't seem to make sense of it. Do I need to send a PC on one midi channel and a CC on a different midi channel. Having same issue with my bandmates PodGO. Have to turn off stomp and Pod Go and turn back on to get them to work again. using this command,,,,,[midi: PC0@6, CC69.0@6] in song lyrics.

peter

Maybe the Stomp locks up because it needs a bit of time to process the program changes. So I would send the CC a bit later after the PC command.

HughB

If the snapshot is in a different bank then it would require a PC32 midi command

nstn5266

That’s exactly what is happening. I put the cc command in the midi@play command and it worked with no issues. So the stomp and pod go don’t like 2 commands at the same time. But I would like to do both when the song loads. Is there a way to have a short delay between the two MIDI commands sent in load song? Thanks.

peter

ST3 does not have a means to add delays between midi commands. Only by using timestamps but then playback would need to be running.