question about play/pause button

LeesKeys

Using the Stagetraxx play/pause button (not a physical midi remote controller), how do I tie play/pause in Stagetraxx with play/pause in Camelot Pro? I can designate StageTraxx as my remote control source in Camelot Pro, but it wants me to input channel, CC and 0-127 value for a midi remote controller in the play/pause command data

peter

Not sure about the midi commands to send but you can use Settings > Playback Settings and then set the midi command for Play and Stop. They will be sent whenever you manually start or stop playback.

LeesKeys

This works for the "play" part, but if I press the arrow in StageTraxx again to pause the recording, then the recording in Camelot does not pause but continues to play UNTIL I press the button again. At that point, play and pause are out of sync between the two apps. In other words:

I press play in ST3. Playback starts in both StageTraxx and Camelot Pro
I press Pause in ST3. Playback is paused in ST3, but continues in Camelot Pro
I press Play again. Playback resumes in ST3, but pauses in Camelot.

I realize I'm asking about things outside the immediate operation of ST3; still, any help would be appreciated.

peter

Are you sure you are sending the correct command for Stop? That command is sent when you manually stop playback and that works for me just fine.

LeesKeys

that took care of it. Didn't realize I needed to put the same command code in both Play and Stop. Thank you!