How do I send stereo tracks to PA, my click to AUX from my IPAD

garyfariarocks

I use a Bose L1 Model 2 system with a T1 Bose mixer. Right now I i put all my racks into the LEFT cannel and my click into the right. My right cannel goes directly into my in ear, and the tracks get sent from the AUX channel into my in ears and I mix accordingly. The tracks sound so much better in stereo, but I don't want the click to go into the system.
I'm not sure to route 4 channel audio output, but what I want is my backing tracks to go into the mixer in stereo, then route to an AUX (in ear monitoring) and my click track to completely by pass the mixer and go directly to my in ear. My IPAD is a couple of years older and has the 1/8" out as well as lightening.

Any help here? What cable do I need? or do I make one?

Thanks
GF

peter

You need an USB audio interface that has multiple outputs and works with iOS. Most class compliant audio interfaces will work but require too much power, so either get one that has its own power supply or use a powered usb hub between iPad and the interface.

steverogerok

Hi Peter - I have an uncanny similar setup to Gary except I connect via a macbook air, so I guess I do not need to worry about interface power. However I currently use a Roland Rubix 22 which as you have guessed only has two output channels. So are you saying if I change it to an Audio Interface device with a minimum of 4 output channels - ST3 will recognise them and then allow me to route the different tracks via the audio routing section in settings?

regards

Steve

peter

Yes, Stage Traxx can route each output bus (main, aux 1, aux2 and aux3) to a seperate output pair on your interface.